您要查找的是不是：
- Acetonitrile was selected as porogen (solvent). 选择乙腈为成孔剂（溶剂）。
- Nano-porous fluoro polymer fiber mats with PVP K30 used as porogen has highest tensile strength. 以PVP K30为致孔剂所得含氟聚合物纳米多孔纳米纤维膜的拉伸强度最高。
- A novel method was developed to prepare porous chitosan membranes with dibutyl phthalate as the porogen. 以邻苯二甲酸二丁酯为致孔剂,制备了多孔壳聚糖膜。
- The effect of the amount of porogen, crosslinker and MAA on the latex morphology was studied. 系统研究了致孔剂用量和交联剂对乳胶粒形态的影响。
- The influences of pretreatment of capillary and porogen solvent on porous structure and permeation were investigated. 实验考察了毛细管内壁处理方法，致孔剂组成对整体固定相孔结构和通透性的影响。
- Then the MIP coating was copolymerized and anchored onto the surface of the silica monolith. Acetonitrile was selected as porogen (solent). 然后分子印迹化合物通过与硅胶整体柱上的烯基发生共聚反应从而固定在其表面。选择乙腈为成孔剂（溶剂）。
- The effect of porogen,mass ratio of the two networks and crosslinking degree of the second networks on the pore structure of the PDV. 交联剂和致孔剂是影响树脂合成的关键因素,通过改变它们的种类和比例可以得到不同孔结构的吸附树脂。
- When the content of CMCS is 40% and the ratio of composite and porogen is 1:1 the porosity ratio is about 75% and the compressive strength can exceed 21MPa which should be desirable for bone tissue engineering. 当复合材料中CMCS含量为40%25,复合材料/造孔剂的质量比为1:1时,多孔材料的孔隙率接近75%25,其抗压强度可达21MPa以上,可以满足骨组织工程支架材料的要求。
- In this work, the PSt and P(St-MAA) latex particles with porous and nanocapsule structure were successfully synthesized via miniemulsion polymerization using different alkane as the porogen. 本文分别以不同的烷烃作制孔剂，用细乳液聚合法成功制备了具有多孔和微胶囊结构的聚苯乙烯和苯乙烯/甲基丙烯酸共聚微球。
- Keywords molecular template polymer;non-covalence method;porogen;review; 分子模板聚合物;非共价法;致孔剂;综述;
- tretic 孔生[产孢]的
- tretic conidium 孔出分生孢子
- porogenous (分生孢子)孔生的
- porogen 致孔剂
